MIL-C-82632 Connector Kit, Splice, Single WireThis specification establishes the minimum requirements for the procurement of a single wire splice connector, DL 5545977. The connector joins the shipboard guidance wire to the torpedo guidance wire and maintains electrical continuity in seawater to a pressure of 1500 psig. The connector will accept wire sizes from AWG 25 to AWG 23 and is of one type and class.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22

MIL-C-82632A(OS)

shall be applied for a peroid of not less than 30 seconds,

(d) This force shall be applied with 100 milliamps flowing through the test

sample and a discontinuity monitor connected to check for any circuit opens which

might occur. The connector shall meet the requirements of 3.5.4.

(e) The tensile force shall then be increased to destruction and the force

and type of destruction noted.

4.5.5 Rejection criteria. Failure of a connector or part in the first article

or quality conformance sample to successfully pass the required inspections and

tests may result in rejection of the unit or the lot represented, as determined

by the procuring activity.

4.6 Pa ckaging inspection. The inspection of the preservation-packaging and

interior package marking shall be in accordance with the group A and B quality

conformance inspection requirements of MIL-P-116. The inspection of the packing

and marking for shipment and storage shall be in accordance with the quality

assurance provistions of the applicable container specification and the marking

requirements of MIL-STD-129.

5. PACKAGING

5.1 Preservation-packaging Preservation-packaging shall be Level A.

5.1.1 Level A. The wire splice kits shall be packaged as follows:

(a) be each wire splice (dispenser) kit shall be packaged in accordance with

Method 1A-8 of ML-P-116 and in accordance with Dwg 5545977-1.

(b) One each wire splice (torpedo) kit shall be ackaged in accordance with

Method 1A-8 of MIL-P-116 and in accordance with Dwg 555977-2.

5.2 Packing.

Packing shall be Level A.

5.2.1 Level A. The wire splice kits shall be packed as follows:

(a) Twenty-five. wire splice (dispenser) kits packaged in accordance with

5.1.1. (a) shall be packed into a W5C fiberboard box accordance with PPP-B-636.

and sealed with tape conforming to PPP-T-76.

(b) Twenty-five wire splice (torpedo) kits packaged in accordance with 5.1.1

(b) shall be packed into" a W5C fiberboard box in accordance with PPP-B-636 and

sealed with tape conforming to PPP-T-76.

5.2.1.1 Cushioning The unit pack, if required, shall incorporate sufficient

Cushioning material to insure adequate protection from damage during shipment. At

the time of packing, the moisure content of the cushioning material shall be no

more than 5 percent.